Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
- 12. Body
   12.1. Maintenance and repair
   12.2. Vinyl furnish
   12.3. Upholstery and rugs
   12.4. Repair of small scratches
   12.5. Repair of dents
   12.6. Repair of openings from a rust or dents
   12.7. Filling and painting
   12.8. Repair of considerable damages
   12.9. Loops and locks
   12.10. Windscreen and motionless glasses
   12.11. Removal and installation of doors
   12.12. Door adjustment
   12.13. Removal and cowl installation
   12.14. Cowl adjustment
   12.15. Cover of a back compartment
   12.16. Bumpers
   12.17. Forward facing lattice
   12.18. External mirrors
   12.19. Forward aerial
   12.20. Removal and installation covered
   12.21. Body support (fastening to the chassis)
   12.22. Hatch
   12.23. Holder of a spare wheel
   - 12.24. Salon equipment
      12.24.1. Forward panel and guard of devices
      12.24.2. Panels of auxiliary devices and equipment, floor sections
   12.25. Internal panels of doors
   12.26. Facing panels of salon
   12.27. Ceiling upholstery
   12.28. Switch of the door lock
   + 12.29. Door glass, window regulator and window regulator electric motor
   12.30. Windscreen
   12.31. Back glass
   12.32. Vnutrisalonnoye rear-view mirror
   + 12.33. Seats
   12.34. Seat belts
+ 13. Electric equipment
+ 14. Electroschemes




12.24.2. Panels of auxiliary devices and equipment, floor sections

PERFORMANCE ORDER
1. For removal of these panels at first it is necessary to dismantle the equipment established on these panels (hours, the receiver, etc.).
2. For removal of floor section it is necessary to turn out the handle of the lever of a manual transmission.
3. It is not necessary to remove the handle of the selector of an automatic transmission, – it passes through an opening in the panel.
4. For removal of the panel it is necessary to remove caps and to unscrew the screws which majority is near an ashtray and a tray.
5. For an otvorachivaniye of lateral screws of fastening it is recommended to remove forward seats.
6. In back panels and on a part of forward floor panels grooves for seat belts are provided. At removal of the panel pass belts through these grooves, without assorting belt fastening to a body.
7. At removal of the panel disconnect all wires, previously them having marked.
8. At installation of panels and sections at first it is necessary to establish precisely them in a place, to wrap screws on 1–2 turns and to tighten.