Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
- 12. Body
   12.1. Maintenance and repair
   12.2. Vinyl furnish
   12.3. Upholstery and rugs
   12.4. Repair of small scratches
   12.5. Repair of dents
   12.6. Repair of openings from a rust or dents
   12.7. Filling and painting
   12.8. Repair of considerable damages
   12.9. Loops and locks
   12.10. Windscreen and motionless glasses
   12.11. Removal and installation of doors
   12.12. Door adjustment
   12.13. Removal and cowl installation
   12.14. Cowl adjustment
   12.15. Cover of a back compartment
   12.16. Bumpers
   12.17. Forward facing lattice
   12.18. External mirrors
   12.19. Forward aerial
   12.20. Removal and installation covered
   12.21. Body support (fastening to the chassis)
   12.22. Hatch
   12.23. Holder of a spare wheel
   + 12.24. Salon equipment
   12.25. Internal panels of doors
   12.26. Facing panels of salon
   12.27. Ceiling upholstery
   12.28. Switch of the door lock
   + 12.29. Door glass, window regulator and window regulator electric motor
   12.30. Windscreen
   12.31. Back glass
   12.32. Vnutrisalonnoye rear-view mirror
   + 12.33. Seats
   12.34. Seat belts
+ 13. Electric equipment
+ 14. Electroschemes

12.12. Door adjustment


The door is regulated in 6 directions.

At the correct adjustment the panel of a door should be aflush with adjacent panels of a body.

The provision of a door along a surface of a body is regulated by its moving at the released bolts of fastening of loops to a body.

Vystupaniye of a door over a surface of a body is regulated at the released bolts of fastening of loops to a door.

Reliability of locking of a door is defined by the provision of a clamp of the lock of a door.

The manufacturer provided also installation of adjusting plates under a clamp.

At the correct adjustment the door should not be displaced up or down at a zakhlopyvaniye.

1. For adjustment of a clamp release screws (at the left) fastenings by a shock screw-driver (these screws are tightened hardly (on the right – an adjusting plate)).
2. Then move a clamp and close a door, keeping the external handle in unlocking situation.
3. Tighten screws when locking door by a latch (the latch uvula thus comes into a clamp).
4. At the correct adjustment of a door the clamp is regulated only in the horizontal direction.