Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
- 12. Body
   12.1. Maintenance and repair
   12.2. Vinyl furnish
   12.3. Upholstery and rugs
   12.4. Repair of small scratches
   12.5. Repair of dents
   12.6. Repair of openings from a rust or dents
   12.7. Filling and painting
   12.8. Repair of considerable damages
   12.9. Loops and locks
   12.10. Windscreen and motionless glasses
   12.11. Removal and installation of doors
   12.12. Door adjustment
   12.13. Removal and cowl installation
   12.14. Cowl adjustment
   12.15. Cover of a back compartment
   12.16. Bumpers
   12.17. Forward facing lattice
   12.18. External mirrors
   12.19. Forward aerial
   12.20. Removal and installation covered
   12.21. Body support (fastening to the chassis)
   12.22. Hatch
   12.23. Holder of a spare wheel
   + 12.24. Salon equipment
   12.25. Internal panels of doors
   12.26. Facing panels of salon
   12.27. Ceiling upholstery
   12.28. Switch of the door lock
   + 12.29. Door glass, window regulator and window regulator electric motor
   12.30. Windscreen
   12.31. Back glass
   12.32. Vnutrisalonnoye rear-view mirror
   + 12.33. Seats
   12.34. Seat belts
+ 13. Electric equipment
+ 14. Electroschemes






12.34. Seat belts
GENERAL INFORMATION

Standard design of seat belts of a forward seat on 2-door (above) and on a 4-door body
1. Overlay of an average rack of a body
2. Belts 		3. Socket
4. Buckle lock

Standard design of seat belts of a back seat on 2-door (above) and on a 4-door body
1. Cover of the mechanism of a tension 2. Belts

Belts fasten to a body the bolts closed by caps.

PERFORMANCE ORDER
1. Remove caps and unscrew a bolt of fastening of a natyazhitel of a belt, the top and bottom fastenings of a belt.
2. At removal of a belt designate and disconnect wires of the switch of a reminding signal (if it is provided).
3. Installation is carried out upside-down.
4. Tighten fastenings according to the demanded moments.