Mitsubishi Pajero
1982-1998 of release
Repair and car operation
Mitsubisi Padzhero
+
1.1. Dashboard and control units
+
2. Maintenance
+
3. Engines
+
4. Cooling system
+
5. Greasing system
+
6. Power supply system
+
7. Release system
+
8. Fuel system
+
9. Running gear
+
10. Suspension bracket and steering
+
11. Brake system
-
12. Body
12.1. Maintenance and repair
12.2. Vinyl furnish
12.3. Upholstery and rugs
12.4. Repair of small scratches
12.5. Repair of dents
12.6. Repair of openings from a rust or dents
12.7. Filling and painting
12.8. Repair of considerable damages
12.9. Loops and locks
12.10. Windscreen and motionless glasses
12.11. Removal and installation of doors
12.12. Door adjustment
12.13. Removal and cowl installation
12.14. Cowl adjustment
12.15. Cover of a back compartment
12.16. Bumpers
12.17. Forward facing lattice
12.18. External mirrors
12.19. Forward aerial
12.20. Removal and installation covered
12.21. Body support (fastening to the chassis)
12.22. Hatch
12.23. Holder of a spare wheel
+
12.24. Salon equipment
12.25. Internal panels of doors
12.26. Facing panels of salon
12.27. Ceiling upholstery
12.28. Switch of the door lock
+
12.29. Door glass, window regulator and window regulator electric motor
12.30. Windscreen
12.31. Back glass
12.32. Vnutrisalonnoye rear-view mirror
+
12.33. Seats
12.34. Seat belts
+
13. Electric equipment
+
14. Electroschemes
12.31. Back glass
GENERAL INFORMATION
Back glass (on an insert – a profile of put glue in section A-and (type 3M Super Fast Urethane Auto Glass Sealant 8609 or equivalent))
1. Electroheater conclusions
2. Fringing
3. Glass
4. Clamp
Places and a profile of drawing of a filler and glue on back glass
1. Fringing of back glass
3. Filler
4. Filler drawing on sections A-and, V-in, C-C
5. Filler drawing from a body on section A-and
6. Filler drawing on section B-in
7. Filler drawing on section C-C
8. Glue drawing on sections A-and, V-in, C-C
9. Glue
Removal and installation
PERFORMANCE ORDER
1.
Remove from a window electroheater conclusions.
2.
Remove glass (see
subsection 12.30
).
3.
Remove from glass clamps.
4.
At installation of the termination of clamps should be combined with grooves in a body aperture (a back cover).
5.
Installation see in
subsection 12.30
.