Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
- 9. Running gear
+ 9.1. Mechanical transmission
+ 9.2. Coupling
- 9.3. Automatic transmission
9.3.1. Adjustments
- 9.3.2. The blocking switch
9.3.2.1. Switch adjustment
9.3.3. Check of adjustment of a cable of management by transmission
9.3.4. Mechanism of management of transmission
9.3.5. Epiploon of a shaft of a case of transmission
9.3.6. Removal and transmission installation
9.3.7. Transfer case
9.3.8. Forward and back epiploons
+ 9.3.9. Forward driveshaft and crosspieces
+ 9.3.10. Back driveshaft and crosspieces
9.3.11. Forward leading axis
9.3.12. A nave with a manual unblocking
9.3.13. A nave with an automatic unblocking
9.3.14. Forward semi-axes and epiploons of a forward axis
9.3.15. Reducer of a forward axis
9.3.16. Dismantling of CV JOINTS
+ 9.4. Zadny Bridge
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes
|
CARS OF 1983-86.
| PERFORMANCE ORDER |
|
1. Transfer the selector to situation N, tighten screws of fastening and check chain existence between BY-BY switch conclusions (1 – a starting position, 2 – sector of isolation of contacts, 3 – the probe, 4 – to a forward part of the car). |
| 2. Move the switch in both parties and establish in situation in which the ohmmeter will show a chain. |
|
3. Move the switch so that between it and the selector there was a gap of 1,5 mm, tighten screws. |
|
CARS OF 1987-89.
| PERFORMANCE ORDER |
|
1. Release screws of fastening and establish the selector so that position of the probe (2) on the termination of draft corresponded neutral (1). |
|
2. Check chain existence between conclusions of the socket of the switch 2-BY and 2-BY, moving the switch. |
| 3. Designate the provision of an arm. |
|
4. Establish a gap of 2,5 mm between the switch and a guard of the lever and tighten screws. |
|
CARS OF 1990-98.
Adjustment of position of the switch
| PERFORMANCE ORDER |
| 1. Transfer the selector to situation N, tighten screws. |
| 2. Release a lock-nut of a tip of a cable on the left side of a transmission case. |
| 3. Release a bolt of fastening of the switch. |
|
4. Having turned the switch, combine ledges (2) on the switch with the lever (1) fixing neutral situation (3 – the lever of fixing of the neutral situation V4AW2). |
| 5. Tighten a bolt with the moment of 6 N of m. |
|
6. Submit a cable in the direction of an arrow and tighten a nut with the moment of 24 N of m (1 – an adjusting nut; 2–cable). |
| 7. Be convinced. that the selector is in situation N. |
| 8. Transfer the selector to all provisions and check its fixing. |
|
|
|