Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
- 10. Suspension bracket and steering
   10.1. Wheels
   - 10.2. Forward suspension bracket
      10.2.1. Torsion
      10.2.2. Shock-absorber
      10.2.3. Top spherical support of a suspension bracket
      10.2.4. Bottom spherical support
      10.2.5. Stabilizer of cross-section stability
      10.2.6. Top lever of a suspension bracket
      10.2.7. Bottom lever of a suspension bracket and replacement of plugs
      10.2.8. Rotary fist
      10.2.9. Bearing of a forward wheel
      10.2.10. Corners of installation of wheels
   + 10.3. Back suspension bracket
   + 10.4. Steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






10.2.8. Rotary fist
GENERAL INFORMATION

Order of dismantling of a fist
1. Epiploon
2. Washer
3. Needle bearing 		4. Fist
A.Smazat

Removal and installation

PERFORMANCE ORDER
1. Unblock a nave, having switched the lever of a transfer case in situation 2Н and having passed a backing of 2 m.
2. Lift a front of the car and remove a wheel.
3. Remove blocks and a support, take a support aside and fix.
4. Remove a brake disk assembled with a nave and bearings.
5. Will hang out the bottom lever a jack, выпрессуйте a finger and disconnect from a fist steering draft.
6. Vypressuyte both spherical support strippers Mv990778-01 and Mv990809-01, nuts of support thus release, but completely do not turn on.
7. Lower the bottom lever a little and remove a fist.

Replacement of the needle bearing and epiploon

PERFORMANCE ORDER
1. Disassemble a fist, having beaten out a brass opravka an epiploon, a washer and the bearing.
2. At assembly grease and press the new bearing aflush with a fist surface a special opravka.
3. Press a new epiploon, fill with greasing an epiploon cavity.
4. Establish a fist upside-down.
5. Nuts of support and a finger of steering draft tighten according to the demanded moments. Bolts of a support tighten with the moment of 80-100 N of m.