Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
- 10. Suspension bracket and steering
   10.1. Wheels
   - 10.2. Forward suspension bracket
      10.2.1. Torsion
      10.2.2. Shock-absorber
      10.2.3. Top spherical support of a suspension bracket
      10.2.4. Bottom spherical support
      10.2.5. Stabilizer of cross-section stability
      10.2.6. Top lever of a suspension bracket
      10.2.7. Bottom lever of a suspension bracket and replacement of plugs
      10.2.8. Rotary fist
      10.2.9. Bearing of a forward wheel
      10.2.10. Corners of installation of wheels
   + 10.3. Back suspension bracket
   + 10.4. Steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






10.2.5. Stabilizer of cross-section stability

GENERAL INFORMATION

Details of fastening of the stabilizer of cross-section stability (1992-93)

Removal order
1. Gryazeotrazhatel
2. Rack
3. Collar
4. Plug
5. Stabilizer bar

Details of fastening of the stabilizer of cross-section stability (1994-95)

Removal order
1. Gryazeotrazhatel
2. Rack
3. Collar
4. Plug
5. Stabilizer bar

CARS OF 1983-91.

PERFORMANCE ORDER
1. Lift a car front, remove wheels and a gryazeotrazhatel.
2. Unscrew nuts of fastening of a rack of the stabilizer to a cross-piece and to the bottom levers. Pay attention to an arrangement of plugs, washers and laying.
3. Remove the stabilizer, check its condition.
4. At detection of cracks and deformations replace. It is recommended to replace all rubber plugs also.
5. Installation is carried out upside-down.
6. Tighten a rack nut.
7. Replace the top nut of fastening of a rack of the stabilizer and wrap it on 6–8 mm from the carving termination of a rack.
8. Replace nuts of the bottom lever, tighten nuts so that the carving part acted on 6–8 mm (1982-91).
9. On cars of 1992-98 tighten a nut that the carving part of a bolt acted on 6–8 mm at length of a bolt of 55 mm, or on 8–9 mm at length of 60 mm.

CARS OF 1992-98.

PERFORMANCE ORDER
1. Lift a car front, remove wheels and a gryazeotrazhatel.
2. Unscrew nuts of fastening of a rack of the stabilizer to a bar and to the bottom levers. Pay attention to an arrangement of plugs, washers and laying.
3. Remove collars and a bar, remove from a plug bar.
4. Check existence of cracks and deformations.
5. It is recommended to replace all rubber plugs irrespective of their condition.
6. Installation is carried out upside-down.
7. Tighten bolts and nuts.