Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
- 10. Suspension bracket and steering
   10.1. Wheels
   - 10.2. Forward suspension bracket
      10.2.1. Torsion
      10.2.2. Shock-absorber
      10.2.3. Top spherical support of a suspension bracket
      10.2.4. Bottom spherical support
      10.2.5. Stabilizer of cross-section stability
      10.2.6. Top lever of a suspension bracket
      10.2.7. Bottom lever of a suspension bracket and replacement of plugs
      10.2.8. Rotary fist
      10.2.9. Bearing of a forward wheel
      10.2.10. Corners of installation of wheels
   + 10.3. Back suspension bracket
   + 10.4. Steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes




10.2.1. Torsion

GENERAL INFORMATION

Torsion of a forward suspension bracket

1. Cover
2. Lever торсиона
3. Torsion

Removal

PERFORMANCE ORDER
1. Lift a car front.
2. Remove a wheel.
3. Will hang out the bottom lever a jack.
4. Remove covers from both terminations торсиона.
5. If removed торсион it will be established again, designate its situation.
6. Unscrew a nut and get торсион from the suspension bracket lever.

Installation

PERFORMANCE ORDER
1. Installation is carried out upside-down taking into account the following.
2. Removed торсион establish on the put labels, new – on a white strip which is combined with a label on the lever (a strip it should be turned forward, do not mix right and left торсионы).
3. When collecting sustain the size A.Dlya of cars of 1983-91 A=13,5-14,2 cm (left торсион) and 12,4–13,2 cm (right торсион), for cars of 1992-98 А=14,9 cm (left торсион) and 14,85 cm (right торсион).
4. Adjust a road clearance of a forward suspension bracket (establish the size B) for what on removed торсионе wrap a nut before its situation before dismantling, on new торсионе wrap a nut, having established the size B: for cars of 1983-91. In no more than 6,1 cm (left торсион) and no more than 7,1 cm (right торсион), for cars of 1992-98 the size B no more than 8,0 cm (both торсиона).
5. Fill covers with greasing.
6. After lowering of the car check distance between an arm of the buffer and the limiter (1983-91) (at the left) or between the buffer and the limiter (1992-98) (on the right). These distances should be 71–79 mm and 21–23 mm respectively.
7. If necessary adjust, rotating a bolt nut торсиона.