Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
- 10. Suspension bracket and steering
   10.1. Wheels
   - 10.2. Forward suspension bracket
      10.2.1. Torsion
      10.2.2. Shock-absorber
      10.2.3. Top spherical support of a suspension bracket
      10.2.4. Bottom spherical support
      10.2.5. Stabilizer of cross-section stability
      10.2.6. Top lever of a suspension bracket
      10.2.7. Bottom lever of a suspension bracket and replacement of plugs
      10.2.8. Rotary fist
      10.2.9. Bearing of a forward wheel
      10.2.10. Corners of installation of wheels
   + 10.3. Back suspension bracket
   + 10.4. Steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

10.2.10. Corners of installation of wheels

GENERAL INFORMATION

Corners of installation of forward wheels are checked and regulated only in car-care center.

Corner of a longitudinal inclination of an axis of turn

At violation of this corner the car badly "holds the road", and the wheel does not come back (or slowly comes back) to the provision of driving on a straight line after turn. It is regulated by moving of an axis of the top lever.

On considered cars this corner positive also should make 2°00 '-3°00' on and/m 1983-88 and 2°00 '-3°50' on and/m 1988-98.

Disorder of wheels

It is regulated by selection of washers (adjusting laying).

On considered cars this corner positive also should make 0°30 '-1°30' on and/m 1983-91, 0°10 '-1°10' on and/m 1992-94 and 0°17 '-1°17' on and/m 1998.

Corner of a convergence of wheels

It is regulated by change of length of steering draft at the weakened lock-nut.

The convergence is measured in mm, on considered cars the convergence of forward wheels positive and should be 2–9 mm on and/m 1983-91, 2–7 mm on and/m 1992-98.