Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
- 10. Suspension bracket and steering
   10.1. Wheels
   - 10.2. Forward suspension bracket
      10.2.1. Torsion
      10.2.2. Shock-absorber
      10.2.3. Top spherical support of a suspension bracket
      10.2.4. Bottom spherical support
      10.2.5. Stabilizer of cross-section stability
      10.2.6. Top lever of a suspension bracket
      10.2.7. Bottom lever of a suspension bracket and replacement of plugs
      10.2.8. Rotary fist
      10.2.9. Bearing of a forward wheel
      10.2.10. Corners of installation of wheels
   + 10.3. Back suspension bracket
   + 10.4. Steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






10.2.2. Shock-absorber

GENERAL INFORMATION

Assembly order of the top fastening of the shock-absorber (1992-98)

1. Lock-nut

2. Nut

Installation of details of fastening of the shock-absorber with remote regulation (1992-98)

1. Drive surface

2. Nut

3. Washer

4. Hairpin

5. End face of a hairpin of the shock-absorber

Size B = 1,5–2,5 mm

Removal and installation

PERFORMANCE ORDER
1. Lift a car front on height, sufficient for access to the top fastening of the shock-absorber.
2. Remove a wheel.
3. Unscrew a nut of the top fastening, remove the rubber buffer and a washer.
4. Unscrew a bolt (ы) the bottom fastening and remove the shock-absorber.
5. At assembly establish the shock-absorber, buffers and wrap nuts and a bolt (ы), without tightening.

6. Soriyentiruyte the shock-absorber so that marking of white color (1) was turned aside from the car. On cars of 1992-98 tighten a bolt nut with the moment of 88-103 N of m, on other cars tighten bolts of the bottom fastening with the moment of 9-14 N of m.

7. On cars of 1992-98 tighten a nut of the top fastening so that the A=1-2 size of mm.
8. Wrap a nut of the top fastening before the carving termination, then turn and tighten a lock-nut with the moment of 12-18 N of m.