Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   - 11.15. Hand brake
      11.15.1. Adjustment of a cable (1983-91)
      11.15.2. Cable of the hand brake
      11.15.3. Lever of the hand brake
      11.15.4. Blocks of the hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






11.15.2. Cable of the hand brake

GENERAL INFORMATION

Cables of the hand brake (1983-91)

1. Drum
2. Bolt
3. Guard
4. Cables

Cable of the hand brake (1992-98) (on inserts – greasing places hermetic 3M ATD (at the left) and SAE J310 NLGI N1 greasing 8513)

1. Back brake
2. Disk
3. Regulator spring
4. Cup
5. Probe of a clamping spring of a block
6. Regulator
7, 8. Spring
9. Strut
10. Strut of a spring of a block
11. Block
12. Guard
13. Cable

Removal and installation

PERFORMANCE ORDER
1. Lift the car and remove back wheels.
2. Remove drums (or disks).
3. Unscrew a nut of a natyazhitel of a cable, disconnect a cable from a level of the equalizer and remove a guard.
4. Remove blocks of back brakes (see subsection 11.13.2, subsection 11.14) and disconnect a cable, having turned it a cap natural a cut and having got from the holder on a board.
5. Get a cable from a brake board.
6. Remove brackets and arms of fastening of a cover of a cable to a body and remove a cable.
7. Installation is carried out upside-down.
8. At installation in a board of a brake turn a cable. Track, that the bracket of the holder on a board came into a groove of a cover of a cable, and the ledge of a cover was turned and fixed a cable.
9. Rotating an asterisk, establish diameter of blocks of 253-253,5 mm.