Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   + 11.15. Hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

11.2. Vacuum amplifier of brakes

GENERAL INFORMATION

The vacuum amplifier of brakes (1983-96) for G63В and G54В engines (at the top of) and for a diesel engine


1. Adapter 2. Hose 3. Control valve 4. Pusher 5. Amplifier of brakes	6. Rod fork 7. Remote pro-rate 8. Vacuum switch 9. Tube 10. Plug

Vacuum amplifier of brakes (1987-98)

1. Union
2. Socket
3. Main cylinder
4. Arm
5. Hose

6. Шплинт
7. Axis
8. Amplifier of brakes
9. Adapter

Tightness check

PERFORMANCE ORDER

1. Start the engine and later 1 mines stop.

2. Press several times a brake pedal, – the course of a pedal should decrease with each pressing. Otherwise the amplifier is not tight.

Work check

PERFORMANCE ORDER

1. Press several times a brake pedal.

2. Press slightly a pedal of a brake and start the engine, – the pedal should "leave" to a floor.

Removal and installation

PERFORMANCE ORDER

1. Carefully disconnect from the amplifier of brakes a vacuum hose 2.

2. Remove the main cylinder.

3. Disconnect a rod of the amplifier from a pedal.

4. Unscrew bolts and nuts of fastening of the amplifier to a partition of a motor compartment and remove the amplifier, remove laying and a remote pro-rate.

5. Installation is carried out upside-down.

6. Tighten all connections according to the demanded moments.