Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   - 11.14. Back disk brakes (1992-98)
      11.14.1. Replacement of blocks
      11.14.2. Brake support
      11.14.3. Disk of a back brake
   + 11.15. Hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






11.14. Back disk brakes (1992-98)

11.14.1. Replacement of blocks
GENERAL INFORMATION

On the most part of cars the indicator of wear of blocks is provided. If when using brakes characteristic squeal is distributed, check wear of blocks. If the indicator adjoins to a brake disk, it is necessary to replace blocks.

 The residual thickness of blocks can be checked through a window in a support, for more detailed survey (uniformity of wear on the planes and condition checks) blocks should be removed. Limiting residual thickness of blocks of 2,0 mm.

PERFORMANCE ORDER
1. Lift a front of the car and remove a wheel.
2. Remove a part of liquid from a tank.
3. Unscrew the bottom finger, cast away a support and fix. Do not allow removal of protective greasing of a finger of a support, or dirt hit on it.
4. Remove blocks, plates and brackets, remember an arrangement of these details.

Installation

PERFORMANCE ORDER
1. Drown the piston in the support cylinder by means of a clamp, watching liquid level in a tank (at installation of new blocks it is necessary to take away the piston on considerable distance).
2. Establish plates, brackets and new blocks in a former order. If the top and bottom brackets are provided, it is necessary to replace them together with blocks.
3. Establish a support, a wheel and lower the car.
4. Press a pedal several times that blocks nestled on a disk.
5. Check liquid level, if necessary add.
6. Start the engine and again press several times a brake pedal, check rigidity of a pedal.
7. At the first 15 km of run with new blocks avoid sharp braking.