Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   - 11.14. Back disk brakes (1992-98)
      11.14.1. Replacement of blocks
      11.14.2. Brake support
      11.14.3. Disk of a back brake
   + 11.15. Hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






11.14.3. Disk of a back brake

Removal and installation

PERFORMANCE ORDER
1. Lift a back part of the car and remove a wheel.
2. Remove a support with an arm and blocks, fix a support.
3. Remove a support arm.
4. Designate the provision of a disk, unscrew bolts and nuts and remove a disk.
5. Assembly is carried out upside-down.

Condition check

PERFORMANCE ORDER
1. At detection of strong damages (a vykrashivaniye, задиров, the strong development, the raised roughness of a surface) or in case of the increased palpation a disk replace.
2. The disk also changes, if its thickness in any point less maximum permissible.
3. Check disk palpation for 1 turn, having established an indicator leg in 15 mm from disk edge (the support and blocks thus should be removed). Palpation should not exceed 0,15 mm.