Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   + 11.15. Hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






11.18. Overload sensor
GENERAL INFORMATION

The overload sensor till 1993 (at the top of) and since 1994.

 The sensor is mounted near the lever of the hand brake.

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove the back floor panel.
3. Disconnect from the sensor the socket, unscrew 2 bolts and remove the sensor.
4. After installation of the sensor check system work in car-care center.

CONTROL UNIT

The control unit is mounted on a mudguard, is under the back right panel.

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove the third seat (if it is provided).
3. Remove the right panel in the lower part of a back compartment (see subsection 12.26).
4. Unscrew 4 screws and remove a big arm.
5. Unscrew 2 screws, disconnect the socket and remove the control unit with a small arm.
6. Installation is carried out upside-down.