Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   - 11.13. Back drum-type brakes
      11.13.1. Brake drums
      11.13.2. Replacement of blocks
      11.13.3. Wheel cylinder of back brakes
      11.13.4. Board of a back drum-type brake
   + 11.14. Back disk brakes (1992-98)
   + 11.15. Hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

11.13.2. Replacement of blocks

GENERAL INFORMATION

Blocks should be removed from each wheel separately.

PERFORMANCE ORDER

	1. Remove a wheel.
	2. For removal of a drum wrap bolts about special openings.
	3. Remove a drum, wrapping auxiliary bolts.
	4. After removal of a drum examine a brake and define the provision of details.
	5. Clear brake details special liquid.
	6. Remove coupling springs of blocks and a regulator.
	7. Turn a cup of a clamping spring of a block.
	8. Remove a spring and cups.
	9. Remove a block and disconnect the bottom spring.
	10. Disconnect a torso of the hand brake.
	11. Similarly remove the second block then on a back brake there is a wheel cylinder and a cable.
	12. Remove a lock ring and get a cable from a brake board.
	13. Spread out details as their installation.
14. Assembly is carried out upside-down.
15. Grease a face surface of blocks from a board with SAE J310 N1 greasing.
16. At installation of springs and a regulator execute the following.
17. A regulator tip with the right carving attach to the left block, and a tip with the left carving – to right.
18. Establish a regulator so that the flute was turned outside.
	19. Dress a regulator spring so that the extended party was turned to a bifurcate part of a regulator.
20. Adjust a gap between blocks and a drum, having established external diameter of blocks of 253-253,5 mm.