Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   - 11.15. Hand brake
      11.15.1. Adjustment of a cable (1983-91)
      11.15.2. Cable of the hand brake
      11.15.3. Lever of the hand brake
      11.15.4. Blocks of the hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

11.15.4. Blocks of the hand brake

GENERAL INFORMATION

Drum and blocks of the hand brake (1992-95) (on inserts – greasing places hermetic 3M ATD 8513 (from above) and смазклйSAE J310 NLGI N1)


1. Back disk brake 2. Disk 3. Regulator spring 4. Cup 5. Clamping spring 6. Probe	7. Regulator of blocks 8, 9. Springs of blocks 10. Strut 11. Anchor of a spring of a block 12. Bracket 13. Block

Removal and installation

PERFORMANCE ORDER

1. Lift a back part of the car and remove a wheel.
2. Remove a support, take aside and fix.
3. Remove a brake disk, having designated its situation on a semi-axis.
4. Check a disk and a block.
5. Measure thickness of a frictional material which should be not less than 4,5 mm (a new block of 6,5 mm), a worn-out block replace.
	6. Check internal diameter of a drum of a disk which should be no more than 198 mm, otherwise a disk replace.
7. Disconnect a regulator spring in the lower part of blocks.
8. Turn a cup, remove a clamping spring and the probe.
9. Remove a regulator of blocks.
10. Remove holders of a spring in the top part of a brake.
11. Remove a strut and a spring.
12. Remove a bracket, disconnect a cable and remove blocks.
13. Installation is carried out upside-down taking into account the following.
14. Grease all demanded places.
	15. Correctly place springs of blocks, – the spring of the right (back) block of the hand brake has distinctive coloring.
	16. A regulator of blocks of the left wheel establish so that the hairpin of a regulator was turned towards a back part of the car, the hairpin of a regulator of blocks of the right wheel should be turned forward.
17. Bolts of fastening of a support tighten with the moment of 88 N of m. Adjust the hand brake (see subsection 11.15).