Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
- 10. Suspension bracket and steering
   10.1. Wheels
   + 10.2. Forward suspension bracket
   + 10.3. Back suspension bracket
   - 10.4. Steering
      10.4.1. Removal and wheel installation
      10.4.2. The block of switches on a column
      10.4.3. Ignition lock
      10.4.4. Lock of blocking of a wheel
      10.4.5. Steering column
      10.4.6. Steering drafts
      10.4.7. Pendular lever
      10.4.8. Average steering draft
      10.4.9. Lateral steering drafts
      10.4.10. Steering mechanism
      10.4.11. Pump of the hydraulic booster
      10.4.12. Air removal from the power steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






10.4.12. Air removal from the power steering

PERFORMANCE ORDER
1. Disconnect a high-voltage wire on the ignition coil.
2. Rotate a wheel in both parties, including a starter on 15–20 seconds.
3. Repeat the last operation of 5-6 times, watching liquid level in a tank of the hydraulic booster. Level at turn of a wheel should not change.
4. Attach a wire and start the engine, idling rotate a wheel in both parties against the stop.
5. Level change at turn of a wheel should not exceed 5 mm, and liquid should not be homogeneous (without small vials). If level changes more strongly or if after engine switching off level sharply increases, in the hydraulic booster there is an air.
6. Add liquid and close a tank a stopper.
7. Establish a spare wheel and fix bolts, having tightened them it is insignificant.
8. Lower a wheel. In diagonal sequence tighten bolts of fastening of a wheel the demanded moment.