Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
- 10. Suspension bracket and steering
   10.1. Wheels
   + 10.2. Forward suspension bracket
   + 10.3. Back suspension bracket
   - 10.4. Steering
      10.4.1. Removal and wheel installation
      10.4.2. The block of switches on a column
      10.4.3. Ignition lock
      10.4.4. Lock of blocking of a wheel
      10.4.5. Steering column
      10.4.6. Steering drafts
      10.4.7. Pendular lever
      10.4.8. Average steering draft
      10.4.9. Lateral steering drafts
      10.4.10. Steering mechanism
      10.4.11. Pump of the hydraulic booster
      10.4.12. Air removal from the power steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes




10.4.11. Pump of the hydraulic booster

GENERAL INFORMATION

Tank and pump of the hydraulic booster (1983-89)

Tank
1,2. Hoses
3. Tank
Pump
1, 2, 4. Hoses
5. Belt
6. Pump
7, 8. Pump arms

Pump of the hydraulic booster (1990-98)

1. Pump cover
2. Belt
3, 4. Hoses
5. Ring
6. The socket of the sensor of pressure (except 12-klapanny engines of 3,0 l with MKPP)
7. Pump
8, 9. Pump arms
10. Drain
11. Arm of a natyazhitel
12. Roller of a natyazhitel

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove a tank, disconnect the bottom hose and merge liquid.
3. If the pulley acts in film, release pulley bolts.
4. Release bolts of fastening of the pump and remove a belt.
5. On the 24-klapanny engine of 3,0 l and the engine of 3,5 l a belt remove, having released a bolt of a natyazhitel.
6. Turn the pump by hand and remove the liquid remains.
7. Disconnect from the pump hoses, turn out bolts and remove the pump.
8. Installation is carried out upside-down.
9. At installation of a pressure head hose the groove should be definitely сориентирован.
10. Check a condition of tubes.
11. Tighten all connections with certain moments.
12. Fill in liquid and remove air from the hydraulic booster.