Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
- 3. Engines
   3.1. Candles
   3.2. Check of wires
   + 3.3. Ignition system
   + 3.4. Major maintenance of the engine
   - 3.5. Diesel and turbodiesel engines 2,5 and 2,8 of l
      3.5.1. Removal and engine installation
      3.5.2. Engine dismantling
      3.5.3. Pistons and rods
      3.5.4. Valves and shaft of yokes
      3.5.5. Head of cylinders and valves, shaft of yokes and yoke
      3.5.6. Head of cylinders
      3.5.7. Compression check
      3.5.8. Camshaft and gas-distributing mechanism
      3.5.9. Drive of the mechanism of a gazoraspredeleniye
      3.5.10. Adjustment of gaps of valves
      3.5.11. Adjustment of a tension of a gear belt
      3.5.12. Removal of the bottom protective casing of a gear belt
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






3.5.6. Head of cylinders

 Check

PERFORMANCE ORDER
1. Carefully clear a surface of a head of cylinders of the remains of consolidation and check a distortion of its surface adjacent to the block of cylinders. For this purpose put a steel ruler to a head and insert between a head and a ruler щупы various thickness. If it is possible to insert щуп in the thickness more than 0,20 mm on the engine with working volume of 2,5 l, a head follows or отфрезеровать, or to replace.
2. Consultation about it can be received at service station.

Assembly and installation

Assembly on both types of engines is made equally.

PERFORMANCE ORDER
1. Laying of a head of cylinders has no marking and should be imposed up by the party specified in drawing.
2. Grease a carving of bolts of a head of cylinders with engine oil and insert bolts into openings. Tighten bolts in sequence for some passes till an inhaling of 50 N of m. Then tighten bolts in the same sequence till an inhaling of 105-115 N of m.
3. The specified values belong to the cold engine. On the warmed-up engine the moment of an inhaling of bolts makes 115–125 N of m.