Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   - 11.12. Forward disk brakes
      11.12.1. Blocks of disk brakes
      11.12.2. Brake support
      11.12.3. Brake disk
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   + 11.15. Hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






11.12.2. Brake support
GENERAL INFORMATION

Support of a forward brake (on inserts greasing places before assembly are specified)

  
1. Finger
2. Axis
3. Support assembled
4, 5. Plug
6, 7, 9. Cover
8. Ring
10. Piston
11. Sealant
 12. Case
13, 14. Plates
15. Blocks
16. Bracket
17. Support arm

For greasing the structure from ремкомплекта is used.

Described procedure is applicable also to a 2-cylinder support of cars of 1992-98.

Removal and installation

PERFORMANCE ORDER
1. Lift a front of the car and remove a wheel.
2. Remove a part of liquid from a tank.
3. Disconnect and muffle a hose.
4. Unscrew bolts fastenings (fingers) of a support.
5. Get fingers of a support and store them in the pure container.
6. Remove a support.
7. Remove an external block.
8. Remove a block plate.
9. Remove an internal block.
10. Remove the top and bottom brackets.
11. Installation is carried out upside-down taking into account the following.
12. Drown the piston in the cylinder.
13. Tighten connections with the next moments: support bolts – 32–42 N of m (bottom) and 40–50 N of m (top), the hose union – 17 N of m.
14. Remove air from a hydraulic actuator.

Dismantling

PERFORMANCE ORDER
1. Remove a lock ring of a cover of the piston.
2. Remove a cover.
3. Carefully remove pistons with the compressed air.
4. Carefully get from the cylinder a cuff.
5. Check a condition of pistons.
6. Check a condition of an internal surface of the cylinder.
7. At detection of corrosion and appreciable damages of a detail replace. In ремкомплект a support enter a sealant and the piston (it is delivered also separately), and also greasing for support fingers.
8. Assembly is carried out upside-down.
9. Replace everything a sealant.
10. Remove a piston cover.
11. Take a piston sealant.
12. Grease support fingers with structure from ремкомплекта. The piston grease with brake liquid.