Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
- 6. Power supply system
   6.1. Introduction
   6.2. Air removal from a power supply system
   6.3. Water removal from the fuel filter
   6.4. Replacement of a filtering element of the fuel filter
   6.5. Removal and TNVD installation
   6.6. Idling adjustment
   6.7. Check of system of prestarting heating of the engine 4D56Т
   6.8. Control unit check by prestarting heating
   6.9. Check of the relay of inclusion of starting candles
   6.10. Removal and turbokompressor installation
   6.11. Check of pressure of pressurization
   6.12. Vozdukho-vozdushny cooler
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






6.9. Check of the relay of inclusion of starting candles
GENERAL INFORMATION

Scheme of check of the relay of inclusion of starting candles of the party

PERFORMANCE ORDER
1. Check an ohmmeter integrity of a chain between a conclusion "With" the relay of inclusion of starting candles and an arm of fastening ("weight").
2. Resistance on an ohmmeter should be about 3 Ohm.
3. Wires connect a conclusion "To" the relay of inclusion of starting candles with the plug "+" the storage battery, and an arm of fastening of the relay with the plug "-" the storage battery.
Prevention

Before connection of wires it is necessary to disconnect wires from conclusions "In" and "G" of the relay of inclusion of starting candles. At all do not connect on "weight" conclusions of a block of a bunch of the wires going to the relay of inclusion of starting candles. Pay special attention to the correct connection of wires. Erroneous connection of wires will bring in relay failure.

4. Check integrity of a chain between conclusions "In" and "G" of the relay of inclusion of starting candles, having attached a wire at first to the minus plug of the storage battery, and then having disconnected a wire from the storage battery.