Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
- 6. Power supply system
   6.1. Introduction
   6.2. Air removal from a power supply system
   6.3. Water removal from the fuel filter
   6.4. Replacement of a filtering element of the fuel filter
   6.5. Removal and TNVD installation
   6.6. Idling adjustment
   6.7. Check of system of prestarting heating of the engine 4D56Т
   6.8. Control unit check by prestarting heating
   6.9. Check of the relay of inclusion of starting candles
   6.10. Removal and turbokompressor installation
   6.11. Check of pressure of pressurization
   6.12. Vozdukho-vozdushny cooler
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

6.12. Vozdukho-vozdushny cooler


Vozdukho-vozdushny cooler

1. Heat exchanger

2. Electrofan

3. Protective casing

4. An air pipe connecting a cooler to an inlet branch pipe

5. An air pipe connecting a turbokompressor to a cooler

6. Sensor of turning on of the electrofan

7. Relay


1. Disconnect wires from plugs of the storage battery.
2. Disconnect from a cooler electric wires.
3. Remove a protective casing from a cooler.
4. Remove the relay of management of the electrofan.
5. Disconnect from a cooler both air pipes.
6. Remove a cooler.
7. Remove the sensor of turning on of the electrofan and the electrofan.
8. Remove an arm of fastening of a cooler.


1. Installation of a cooler is carried out as it should be, the return to removal.
2. It is necessary to put new laying under the sensor of turning on of the electrofan.