Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
- 6. Power supply system
   6.1. Introduction
   6.2. Air removal from a power supply system
   6.3. Water removal from the fuel filter
   6.4. Replacement of a filtering element of the fuel filter
   6.5. Removal and TNVD installation
   6.6. Idling adjustment
   6.7. Check of system of prestarting heating of the engine 4D56Т
   6.8. Control unit check by prestarting heating
   6.9. Check of the relay of inclusion of starting candles
   6.10. Removal and turbokompressor installation
   6.11. Check of pressure of pressurization
   6.12. Vozdukho-vozdushny cooler
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






6.2. Air removal from a power supply system

GENERAL INFORMATION

Power supply system elements

1. Fuel filter

2. Blowing-off screw

3. Manual toplivopodkachivayushchy pump

4. The sensor of availability of water in fuel

5. The socket of the sensor of availability of water in fuel

Air filter

 
and and – installation options

1. An air pipe connecting the filter to a turbokompressor
2. Case of the air filter
3. Cover
4. A filtering element
5. Air pipe

It is necessary to delete air from a power supply system in the following cases:

  – removal of one of топливопроводов;
  – engine stops because of a full izraskhodovaniye of fuel;
  – replacements of a filtering element of the fuel filter.

PERFORMANCE ORDER
1. Turn out the blowing-off screw on the case of the fuel filter.
2. Put rags about the fuel filter to avoid a fuel razbryzgivaniye.
3. Working with the lever of the manual toplivopodkachivayushchy pump, pump over system to a fuel exit without air vials from under the blowing-off screw.
4. Wrap the blowing-off screw.
5. Again work as the lever of the manual toplivopodkachivayushchy pump and completely fill system with fuel to what the increased resistance on the pump lever will testify.
6. At not wrapped up unions топливопроводов a high pressure on nozzles press to the full a pedal of gas and include a starter.
7. As soon as fuel will start to leave streams from under unions топливопроводов a high pressure, tighten the union on nozzles.
8. Warm up and start the engine for the purpose of check of leaks in топливопроводах.