Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
- 2. Maintenance
   2.1. Periodicity of service
   2.2. Refueling capacities
   2.3. Filter replacement
   2.4. Fuel filter
   2.5. Zolotnik of ventilation of a case (petrol engines)
   2.6. Care of the battery
   2.7. Drive belts
   2.8. Hoses of system of cooling
   2.9. Covers of CV JOINTS
   2.10. Conditioner service
   2.11. Screen wiper brushes
   2.12. Wheels and tires
   2.13. Recommended fuel, liquids and lubricants
   + 2.14. Engine
   + 2.15. Cooling liquid
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






2.7. Drive belts

GENERAL INFORMATION

Check and tension adjustment

For check of a condition of a belt turn the engine a starter, looking through a belt on all to length. At detection of any defects or wear signs a belt replace. For check of a tension of a belt press a belt in the middle between pulleys and check depth of a deflection of a belt. Measure size of a deflection of a belt which should be 6–10 mm at effort of 9 kgfs.

Adjustment of a tension of a belt of the generator

1. A pulley of the pump of cooling liquid

2. Generator pulley

3. Crankshaft pulley

Bolt of an axis of the generator and bolt of fastening of the unit in an arm cut

At the left – a bolt of an axis of the generator

On the right – a bolt of fastening of the unit in an arm cut


Adjustment of a tension of a belt of the generator


Scheme of adjustment of a tension of a belt moving of a roller of a natyazhitel

1. Adjusting nut

2. Lock-nut of an axis of a roller


Adjustment of a tension of a belt by rotation of an adjusting washer


The scheme of adjustment of a tension of a belt of the generator by moving by bolt rotation




Bolt for adjustment of a tension of a belt on the majority of cars


1. Natyazhitel

2. Tension

3. Bolt

4. Easing

5. Nut


Places of adjustment of a belt of a drive

1. Generator pulley

2, 5. Natyazhitel

3. Generator pulley

4. Crankshaft pulley

Adjustment

PERFORMANCE ORDER
1. If it is necessary to adjust a tension of a belt of the generator or the pump of the hydraulic booster, release a bolt of an axis of the unit.
2. Then a bolt of fastening of the unit in an arm cut.
3. Move the unit, having pulled (or having released) a belt and tighten bolts upside-down.
4. On late models the tension of a belt is regulated by moving of a roller of a natyazhitel by rotation of a nut of a directing hairpin at the released lock-nut of an axis of a roller.

Removal and installation

PERFORMANCE ORDER
For removal of a belt execute the same actions, as at adjustment, only take away a pulley (or the unit) so that a belt it was possible to remove and dress the new. It is forbidden to dress a belt, making excessive effort. Previously be convinced that the belt completely corresponds to the removed.

GEAR BELT

Check integrity of a belt, lack of traces of oil and liquid. The belt changes through each 96000 km. An order of removal look in subsection 3.4.29, subsection 3.4.29.2, subsection 3.4.29.3.