Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
- 2. Maintenance
   2.1. Periodicity of service
   2.2. Refueling capacities
   2.3. Filter replacement
   2.4. Fuel filter
   2.5. Zolotnik of ventilation of a case (petrol engines)
   2.6. Care of the battery
   2.7. Drive belts
   2.8. Hoses of system of cooling
   2.9. Covers of CV JOINTS
   2.10. Conditioner service
   2.11. Screen wiper brushes
   2.12. Wheels and tires
   2.13. Recommended fuel, liquids and lubricants
   + 2.14. Engine
   + 2.15. Cooling liquid
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

2.11. Screen wiper brushes

GENERAL INFORMATION

On cars brushes of several updatings are established.

Scrapers are subject to replacement in case of unsatisfactory purification of glass. For convenience transfer brushes to vertical situation, having switched on and off a cleaner.

Replacement

PERFORMANCE ORDER

1. Raise a shchetkoderzhatel.

2. Press the handle in the center of the holder and remove a brush from the lever.

3. Unbend brackets and get the terminations of brushes from the holder.

4. Establish a new scraper, having tracked reliability of fastening.

Trico model

5. In brushes of the Trico model the button by which pressing the brush leaves the holder is provided.

6. The part of these brushes acts in film by pressing a back part of a framework of a scraper in its widened part.

Anco model

7. In Anco model brushes for removal of a scraper unscrew in the parties special brackets from each party of a shchetkoderzhatel then extend a scraper in the longitudinal direction.

8. At installation of a bracket latch.

Polycarbonate model

9. For removal of a brush of the Polycarbonate type press on a rychazhok, which вытолкнет a brush.

10. At installation the brush is fixed automatically.

Tridon model

11. For removal of a brush of the Tridon type lay it on an equal firm surface and pull for the scraper termination, having turned counter-clockwise to remove a ledge on a scraper from deepening on a plastic substrate.

12. Similarly disconnect a scraper from the holder in other places of fastening.

13. The length of brushes is cast at an end face of a scraper and should correspond to length of a replaced brush.