Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Mitsubisi Padzhero
+ 1.1. Dashboard and control units
- 2. Maintenance
   2.1. Periodicity of service
   2.2. Refueling capacities
   2.3. Filter replacement
   2.4. Fuel filter
   2.5. Zolotnik of ventilation of a case (petrol engines)
   2.6. Care of the battery
   2.7. Drive belts
   2.8. Hoses of system of cooling
   2.9. Covers of CV JOINTS
   2.10. Conditioner service
   2.11. Screen wiper brushes
   2.12. Wheels and tires
   2.13. Recommended fuel, liquids and lubricants
   + 2.14. Engine
   + 2.15. Cooling liquid
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






2.10. Conditioner service
GENERAL INFORMATION

The correct arrangement of a collar when clothing hose

Viewing glass on the cars filled with a coolant of R12

Viewing glass on the cars filled with a coolant of R134a

Service of the conditioner is carried out in a specialized workshop by qualified personnel. To need of dismantling, refilling or repair of knots of this system point appreciable decrease in efficiency of cooling, or a strong obmerzaniye of the evaporator.

In central air R12 or R134а coolant which mixing is not allowed is used.

Check of filling of the conditioner by a coolant can be executed independently. The observation port mounted on a moisture separator, located in a motor compartment is for this purpose provided.

Check

PERFORMANCE ORDER
1. Check is carried out at air temperature about 21 ° With (this check is unacceptable if the car is equipped with the "supernumerary" conditioner).
2. Start the engine.
3. Turn on the conditioner in button pressing, transfer a fan rychazhok to the situation HIGH, and a temperature regulator rychazhok in extreme left situation.
4. Some minutes later check a coolant condition behind viewing glass.
5. If in viewing glass there are no indignations, the compressor is switched on, a final branch pipe of the compressor warm, and inlet – cold, the system is completely filled.
6. If in viewing glass there are no indignations, the compressor is switched on (the magnetic coupling) worked, and distinction of temperature of branch pipes is insignificant, the system is filled. not completely.
7. If in viewing glass of indignation are absent, and the compressor did not turn on (the magnetic coupling) did not work, or the coupling is faulty, or in system there is no coolant.
8. If in viewing glass foaming or vials are observed, the system needs filling, or the moisture separator is polluted.
9. Hand over the car in car-care center.
10. Have in a look that foaming or vials are allowed at air temperature above 43 ° With, or below 21 ° Page.