Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
- 9. Running gear
   + 9.1. Mechanical transmission
   + 9.2. Coupling
   + 9.3. Automatic transmission
   - 9.4. Zadny Bridge
      9.4.1. Semi-axes, bearings and epiploons
      9.4.2. Adjustment axial люфта semi-axes
      9.4.3. Reducer of the back bridge
      9.4.4. Epiploon of a reducer of the back bridge
      9.4.5. Removal and installation of the back bridge
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes


Эвакуатор Аксай и еще.


9.4.4. Epiploon of a reducer of the back bridge

GENERAL INFORMATION

Order of removal of an epiploon of a reducer of the back bridge

1. Reducer
2, 3. Holders of the bearing of the leader
gear wheels of the main transfer
4. Adjusting washer
5. Epiploon
6. Flange
7. Washer
8. Samopodzhimny nut

Removal and installation

PERFORMANCE ORDER
1. Lift the car, merge oil from a reducer.
2. Put oriyentatsionny labels and disconnect the back driveshaft.
3. Measure the moment of resistance a provorachivaniya of a leading gear wheel of the main transfer which should be 0,4–0,5 N of m, this moment should be sustained at assembly.
4. Holding a flange, unscrew a nut and remove a washer.
5. Get a flange of a leading gear wheel, hook and get a reducer epiploon.
6. Assembly is carried out upside-down.
7. A new epiploon press an opravka so that the surface of an epiploon was aflush with the reducer plane.
8. Tighten a flange nut, checking the moment of resistance a provorachivaniya of a leading gear wheel, the final moment of an inhaling of a nut should be 190–250 N of m.