Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
- 9. Running gear
   + 9.1. Mechanical transmission
   + 9.2. Coupling
   + 9.3. Automatic transmission
   - 9.4. Zadny Bridge
      9.4.1. Semi-axes, bearings and epiploons
      9.4.2. Adjustment axial люфта semi-axes
      9.4.3. Reducer of the back bridge
      9.4.4. Epiploon of a reducer of the back bridge
      9.4.5. Removal and installation of the back bridge
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






9.4.2. Adjustment axial люфта semi-axes

PERFORMANCE ORDER
1. On the left semi-axis lay a washer in thickness of 1 mm between the case of the bearing and an end face of a beam of the bridge.
2. Establish the right semi-axis without an adjusting washer and and rings, tighten 4 nuts with the moment of 5,6 N of m.
3. Check a gap between the case of the bearing and an end face of a beam of the bridge.
4. Remove a semi-axis and establish the washers which thickness is equal to the measured gap plus 0,05–0,20 mm.
5. Establish a ring, having greased with hermetic.
6. Establish a semi-axis and tighten nuts with the moment of 54 N of m.
7. Believe axial люфт and continue assembly.