Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
- 9. Running gear
   + 9.1. Mechanical transmission
   - 9.2. Coupling
      9.2.1. Coupling adjustment
      9.2.2. Coupling pedal
      9.2.3. Details of a hummock drive of switching off of coupling
      9.2.4. Coupling with a hydraulic actuator
      9.2.5. Removal and coupling installation
      9.2.6. Main cylinder of coupling
      9.2.7. Working cylinder of switching off of coupling
      9.2.8. Air removal from a coupling hydraulic actuator
   + 9.3. Automatic transmission
   + 9.4. Zadny Bridge
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






9.2.6. Main cylinder of coupling

GENERAL INFORMATION

Details of the main cylinder of coupling

1. Lock ring
2. Rod and damper
3. Piston assembled
4. Stopper
5. Tank
6. Collar
7. Cylinder

Removal and installation

PERFORMANCE ORDER
1. Unscrew partially the union for pumping on the working cylinder and extort liquid.
2. Disconnect a cylinder rod from a pedal.
3. Unscrew a hydraulic actuator tube, bolts (nuts) of fastening and remove the cylinder.
4. Installation is carried out upside-down.
5. Tighten connections with the next moments: fastening bolts – 14 N of m, a nut of the union of a tube – 15 N of m, bolts of a transfer case – 12 N of m.
6. Fill in liquid and remove air from a hydraulic actuator.

Dismantling

PERFORMANCE ORDER
1. Remove the main cylinder.
2. Get a lock ring.
3. Remove a cover and a pusher.
4. Get the piston assembled.
5. Weaken a collar and remove a tank.
6. Check a condition of a surface of the cylinder, existence of corrosion and scratches, check purity of openings of the cylinder.
7. Believe diameter of the cylinder in two mutually perpendicular directions and diameter of the piston. If the gap (a difference of diameters) exceeds 0,15 mm in any point, the cylinder and the piston replace. It is forbidden to remove a spring and other details from the piston.
8. Assembly is carried out upside-down.
9. Grease the piston and the cylinder with brake liquid and establish the piston.
10. The collar сориентируйте so that the screw was in the specified sector.
11. Tighten nuts of fastening of the cylinder with the moment of 10-15 N of m.
12. Remove air from a hydraulic actuator.