Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
- 9. Running gear
   + 9.1. Mechanical transmission
   - 9.2. Coupling
      9.2.1. Coupling adjustment
      9.2.2. Coupling pedal
      9.2.3. Details of a hummock drive of switching off of coupling
      9.2.4. Coupling with a hydraulic actuator
      9.2.5. Removal and coupling installation
      9.2.6. Main cylinder of coupling
      9.2.7. Working cylinder of switching off of coupling
      9.2.8. Air removal from a coupling hydraulic actuator
   + 9.3. Automatic transmission
   + 9.4. Zadny Bridge
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






9.2.3. Details of a hummock drive of switching off of coupling

GENERAL INFORMATION

Details of coupling and switching off mechanism (hummock drive)

1. Transmission
2. A casing of a conducted disk
3. Frictional disk
4. Spring bracket
5. Vyzhimna bearing
6. Spring clamp

7. Consolidation
8, 10. Springs
9. Fork
11. Fork roller
12. Counterbalance
and. To grease


Cable of a drive of coupling

1. Шплинт

2. Cable

3. Plug

CABLE

PERFORMANCE ORDER
1. From a motor compartment submit a cable and unscrew a cover nut, having weakened a cable.
2. Disconnect a cable from a pedal and stretch in a motor compartment.
3. Lift the car.
4. Rasshplintuyte a cable on a check point also extend through an opening in case inflow.
5. Get a cable, having extended it via the plug in an arm.
6. Installation is carried out upside-down.

FORK AND VYZHIMNA BEARING

PERFORMANCE ORDER
1. Remove a check point.
2. Establish spring clamps so that cuts were turned to fork eyes.
3. On removed with a check point remove spring clamps and remove vyzhimny the bearing.
4. Beat out spring clamps of fastening of a fork to the small beards which diameter in accuracy corresponds to diameter of brackets.
5. Remove the roller of a fork, the consolidation, both springs and a fork, having remembered an order of installation of these details.
6. If necessary remove a counterbalance.
7. Installation is carried out upside-down.
8. Replace spring clamps of a fork.
8. Grease the fork roller on 25–37 mm from end faces from both parties.
9. Grease vyzhimny the bearing in the places specified by shading.
10. Grease also rubbing surfaces of eyes of a fork.