Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
- 2. Maintenance
   2.1. Periodicity of service
   2.2. Refueling capacities
   2.3. Filter replacement
   2.4. Fuel filter
   2.5. Zolotnik of ventilation of a case (petrol engines)
   2.6. Care of the battery
   2.7. Drive belts
   2.8. Hoses of system of cooling
   2.9. Covers of CV JOINTS
   2.10. Conditioner service
   2.11. Screen wiper brushes
   2.12. Wheels and tires
   2.13. Recommended fuel, liquids and lubricants
   + 2.14. Engine
   - 2.15. Cooling liquid
      2.15.1. Level check
      2.15.2. Replacement of cooling liquid
      2.15.3. Check of level of liquid of a hydraulic actuator of brakes and coupling
      2.15.4. Nutritious tank of the power steering
      2.15.5. Reducer of the steering mechanism
      2.15.6. Greasing of a running gear
      - 2.15.7. Body greasing
         2.15.7.1. Locks and cowl loops
         2.15.7.2. Door loops
         2.15.7.3. Greasing of bearings of forward wheels (rear-wheel cars)
         2.15.7.4. Car raising jack
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

2.15.7.3. Greasing of bearings of forward wheels (rear-wheel cars)

GENERAL INFORMATION

Nave of a forward wheel

1. Support
2, 9. Cap
3. To grease with hermetic 3M ATD
4. Nave assembled

5. External bearing
6. Washer
7. Nut
8. Шплинт

PERFORMANCE ORDER

1. Remove a nave and a brake disk, remove a disk from a nave (see subsection 11.12.3).

2. Get an epiploon and the internal bearing. If in a normal state, them it is possible to use bearings and further. Worn-out bearings replace, for what beat out rings of bearings from a nave to brass small beards.

3. Rings of bearings are pressed by special opravka or adaptations against the stop in a fillet of a cavity of a nave.

4. Put in bearings and a nave cavity greasing.

5. Opravka press an epiploon so that its surface was aflush with a nave end face.

6. Establish all details upside-down.

Greasing is replaced in 2 years or 48000 km.

At replacement of greasing it is forbidden to wash out bearings in gasoline and to blow them the compressed air. It is allowed to use only weak solvents.