Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
- 9. Running gear
   - 9.1. Mechanical transmission
      9.1.1. Mechanism of management of a check point
      9.1.2. Sensor of switching off of coupling (1990-98)
      9.1.3. Gear shifting lever (and/m 4х4)
      9.1.4. Switch of a signal of movement by a backing
      9.1.5. Epiploon of a shaft of a check point (or leading shaft of a transfer case)
      9.1.6. Removal and check point installation
   + 9.2. Coupling
   + 9.3. Automatic transmission
   + 9.4. Zadny Bridge
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

9.1.3. Gear shifting lever (and/m 4х4)

GENERAL INFORMATION

Details of control levers of a check point and transfer case


1. Handle 2. Plate 3, 9. Cover 4. Check point lever 5, 7, 10, 12. Laying	6. Frame 8. Lever of a transfer case 11. Case 13. To put hermetic 3M ATD N 8660 from both parties

Check point control lever

1. Lever

2. Top section

3. Inserts

4. External cover

5. Vnutrenny cover

6. Sharnirny part

PERFORMANCE ORDER

1. Turn out handles of check points levers and a transfer case.
2. Unscrew screws of fastening of the top plate and remove a plate with a cover.
3. Get the lever assembled with the case for what transfer the lever of a transfer case to situation 2Н (4Н for and/m 1992-98) and unscrew bolts of fastening of the case of a sharnirny part of the lever.
4. Remove 2 laying and a frame.
5. Get the lever of a transfer case.
6. Uncover cases and laying.
7. After removal of check points levers there should be in neutral situation, and a transfer case – in situation 2Н (or 4Н for and/m 1992-98).
8. Assembly is carried out upside-down.
	9. At installation it is necessary to sustain the certain provision of a nest of the lever.
	10. At assembly vozhno it is correct сориентировать a check point lever frame (1 – to a car front).
11. Replace all laying.
12. Tighten all bolts according to the demanded moments.