Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
- 9. Running gear
   - 9.1. Mechanical transmission
      9.1.1. Mechanism of management of a check point
      9.1.2. Sensor of switching off of coupling (1990-98)
      9.1.3. Gear shifting lever (and/m 4х4)
      9.1.4. Switch of a signal of movement by a backing
      9.1.5. Epiploon of a shaft of a check point (or leading shaft of a transfer case)
      9.1.6. Removal and check point installation
   + 9.2. Coupling
   + 9.3. Automatic transmission
   + 9.4. Zadny Bridge
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






9.1.2. Sensor of switching off of coupling (1990-98)

GENERAL INFORMATION

Adjustment of height of a pedal and free wheeling

1. Without cruise control

2. With system cruise control

3. Lock-nut

4. Sensor

5. Bolt

PERFORMANCE ORDER
1. Check height of a platform of a pedal of coupling And and a rod course In the main cylinder which at measurement on a pillow of a pedal there should be 180,5–190,5 mm and 1–3 mm, respectively.
2. If necessary adjust these sizes, having executed the following.
3. On cars without cruise control the size A establish, rotating a bolt at the released lock-nut.
4. On cars with system cruise control disconnect the socket and establish the size A, rotating the sensor case at the released lock-nut.
5. The free wheeling of a rod In is regulated by rotation of a rod of the main cylinder of a drive of coupling at the released lock-nut, thus a rod against the piston of the cylinder not to rest.
6. Be convinced that a free wheeling of a pedal (C) (the distance on which moves a pedal to feeling of considerable resistance to a course) and pedal height at complete switching off of coupling (D) correspond to norm.
7. Free wheeling: and/m 1992-98-6-13 mm, and/m 1990-91-8-16 mm. Pedal height – not less than 35 mm.
8. If free the course and height of a pedal do not correspond to norm, the reason is air hit in a hydraulic actuator, wear of coupling or the main cylinder.