Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
- 8. Fuel system
   + 8.1. Carburetor engines
   + 8.2. Engines with fuel injection
   - 8.3. Diesel engines
      8.3.1. Toplivoprovoda
      8.3.2. Nozzles
      8.3.3. Fuel pump (TNVD)
      8.3.4. Installation of the moment of injection of fuel
      8.3.5. Adjustment of turns of idling
      8.3.6. Adjustment of fast idling
      8.3.7. Spark plugs
      8.3.8. Fuel tank
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






8.3.3. Fuel pump (TNVD)

GENERAL INFORMATION

Prevention

After installation of the pump it is necessary to establish the moment of injection of fuel, what will need the special extension piece with the indicator to measure a vystupaniye of a control rod of TNVD. In the absence of such equipment to remove the pump and to perform on it any works it is forbidden.


Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight
2. Remove the top cover of a gear belt.
3. Unscrew a nut of fastening of an asterisk of TNVD.
4. Expose the piston of the 1st cylinder in VMT of a step of compression, check coincidence of all labels.
5. Press TNVD asterisk by means of a stripper, remove a shponka. After asterisk removal rotation of the crankshaft is not allowed.
6. Disconnect from the pump a jack hose.
7. Disconnect from the pump fuel hoses, having wound them with rags, immediately muffle openings.
8. Disconnect from the pump all wires.
9. Release nuts of unions and remove tubes.
10. Unscrew 2 bolts of fastening, get nuts and washers remove the pump and an arm.

Prevention

At removal of the pump it is forbidden to undertake levers of the accelerating pump or idling.


Installation

PERFORMANCE ORDER
1. Installation is carried out upside-down.
2. Bolts of an arm tighten with the moment of 35 N of m, bolts (nuts) of the pump – with the moment of 26 N of m, a nut of unions – 29 N of m.
3. Establish the moment of injection of fuel, remove air then establish a belt cover.