Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
- 8. Fuel system
+ 8.1. Carburetor engines
- 8.2. Engines with fuel injection
8.2.1. Decompression of fuel system
8.2.2. Fuel pump
8.2.3. Throttle branch pipe
8.2.4. Adjustment of a cable of an accelerator
8.2.5. Nozzles
8.2.6. Pressure regulator
8.2.7. Reduktsionny valve of a tank
8.2.8. Fuel filter
+ 8.3. Diesel engines
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes
|
Laying orientation on a throttle branch pipe (2,4 l)
|
|
1. Branch pipe
2. To a collector
3. Laying
4. Ledge
|
ENGINE OF 2,4 L
Removal
| PERFORMANCE ORDER |
| 1. Execute a decompression and disconnect the battery from weight. |
| 2. Merge liquid. |
| 3. Remove a throttle branch pipe (see subsection 8.2.3). |
| 4. Disconnect from nozzles sockets. |
| 5. Disconnect from the fuel distributor gasoline pipe lines. |
| 6. Remove a pressure regulator.
|
| 7. Remove the fuel distributor, get nozzles, insulators, a sealant and rings. Do not allow hit on dust and dirt nozzles.
|
|
Installation
| PERFORMANCE ORDER |
| 1. Replace all laying and a sealant of nozzles and other removed units. |
| 2. Nozzles establish turn to the right-to the left. |
| 3. Tighten bolts and nuts with the moments specified an illustrations. |
|
ENGINES 3,0 AND 3,5 L
Removal
| PERFORMANCE ORDER |
| 1. Execute a decompression and disconnect the battery from weight. |
| 2. Merge liquid. |
| 3. Remove an inlet collector. |
| 4. Disconnect from the fuel distributor gasoline pipe lines. |
| 5. Remove a pressure regulator.
|
| 6. Disconnect from nozzles sockets.
|
|
7. Unscrew bolts of fastening of an inlet pipe (the fuel distributor uniform on 2 heads). |
| 8. Remove the fuel distributor with форсунами. |
|
9. Get nozzles. On the engine of 3,5 l of a nozzle fasten brackets (1 – a bracket; 2–nozzle). |
|
Installation
| PERFORMANCE ORDER |
|
1. Replace all insulators and a sealant of nozzles, laying from other removed units, being guided by an illustration. |
|
2. Tighten bolts and nuts. |
|
Check of nozzles
Nozzles are checked by listening of clicks through a stethoscope or a long screw-driver, measurement of electric resistance of a winding which should be 13–16 Ohm at 20 ° With, and also on a torch at the stand (it is carried out in car-care center).
Prevention
It is forbidden to check nozzles 12 V-tension from the battery, otherwise they will fail.
|
|