Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
- 8. Fuel system
   + 8.1. Carburetor engines
   - 8.2. Engines with fuel injection
      8.2.1. Decompression of fuel system
      8.2.2. Fuel pump
      8.2.3. Throttle branch pipe
      8.2.4. Adjustment of a cable of an accelerator
      8.2.5. Nozzles
      8.2.6. Pressure regulator
      8.2.7. Reduktsionny valve of a tank
      8.2.8. Fuel filter
   + 8.3. Diesel engines
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






8.2.4. Adjustment of a cable of an accelerator

GENERAL INFORMATION

Cable of an accelerator of engines 3,0 (24-klapanny) and 3,5 l

1. Accelerator cable
2. Cable cruise control
3. Aktyuator
4. Vacuum pump
5. Butterfly valve cable
6, 7. Adjusting bolt
8. Butterfly valve lever
9. Drafts (And, In and C)

Adjustment

ENGINE OF 2,4 L

PERFORMANCE ORDER
1. Adjustment is carried out at the switched-off conditioner.
2. Warm up the engine.
3. Check that turns of idling correspond to norm.
4. Stop the engine.
5. Be convinced of lack of superfluous bends of a cable.
6. Check a free wheeling of a cable in a cover (1–2 mm for and/m from a manual transmission and 3–5 mm for and/m from an automatic transmission).
7. If necessary adjust a cable course, having executed the following.
8. Include ignition on 15 seconds, the engine not to start.
9. Release an adjusting nut completely to weaken the butterfly valve lever.
10. Rotate a nut prior to the beginning of lever movement, release on 1 turn and tighten a lock-nut.
11. Be convinced that the limiter of a cable concerns a drive of the proof-reader of idling.

12-KLAPANNY ENGINE OF 3,0 L

PERFORMANCE ORDER
1. Be convinced of lack of superfluous bends of a cable.
2. Be convinced that draft of a zaslonka concerns the limiter.
3. Release adjusting bolts on an inlet collector and fix a cable cover so that the free wheeling of a cable in a cover was 1–2 mm. If the free wheeling is great, the car will quickly lose speed on liftings, in the absence of a free wheeling of a cable idling turns will increase.
4. Check completeness of opening and butterfly valve closing.

24-KLAPANNY ENGINE OF 3,0 L AND ENGINE OF 3,5 L

PERFORMANCE ORDER
1. Be convinced of lack of superfluous bends of a cable.
2. Be convinced that the lever of a zaslonka concerns the limiter.
3. Be convinced that a free wheeling of a cable in a cover of 1-2 mm.
4. If necessary adjust, rotating an adjusting nut of a cover, which законтрите a lock-nut.