Mitsubisi Padzhero + 1.1. Dashboard and control units + 2. Maintenance + 3. Engines + 4. Cooling system + 5. Greasing system + 6. Power supply system + 7. Release system - 8. Fuel system + 8.1. Carburetor engines - 8.2. Engines with fuel injection 8.2.1. Decompression of fuel system 8.2.2. Fuel pump 8.2.3. Throttle branch pipe 8.2.4. Adjustment of a cable of an accelerator 8.2.5. Nozzles 8.2.6. Pressure regulator 8.2.7. Reduktsionny valve of a tank 8.2.8. Fuel filter + 8.3. Diesel engines + 9. Running gear + 10. Suspension bracket and steering + 11. Brake system + 12. Body + 13. Electric equipment + 14. Electroschemes
|
Fuel tank and pump
Removal and installation
PERFORMANCE ORDER |
1. Remove a rug in a back part of a cargo compartment and remove the hatch. |
2. Execute a decompression. |
3. Unscrew a stopper of a mouth and merge gasoline. |
4. Turn on the union and remove from the pump and muffle hoses and tubes.
|
5. Unscrew nuts of fastening and remove the pump.
|
6. Installation is carried out upside-down. Tighten nuts with the moment of 16 N of m. Before start of the engine turn on the pump on 10 seconds. |
|
Check
PERFORMANCE ORDER |
1. Without removal the pump is checked by tension giving from the battery on a conclusion of the diagnostic socket at the switched-off ignition (the socket is directly connected to the pump and is on the right under the forward panel in salon). If the pump works, whether that press a pressure head fuel hose and check there is a pressure of fuel. |
2. The removed pump connect to the battery on 1–2 seconds, previously plums from it fuel. |
3. It is possible to check also resistance of windings of the pump without its removal, – the ohmmeter should show distinct from zero resistance. |
|
|
|