Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
- 2. Maintenance
   2.1. Periodicity of service
   2.2. Refueling capacities
   2.3. Filter replacement
   2.4. Fuel filter
   2.5. Zolotnik of ventilation of a case (petrol engines)
   2.6. Care of the battery
   2.7. Drive belts
   2.8. Hoses of system of cooling
   2.9. Covers of CV JOINTS
   2.10. Conditioner service
   2.11. Screen wiper brushes
   2.12. Wheels and tires
   2.13. Recommended fuel, liquids and lubricants
   - 2.14. Engine
      2.14.1. Check of level of oil in the engine
      2.14.2. Replacement of oil and oil filter
      2.14.3. Check of level of oil in a manual transmission
      2.14.4. Oil replacement in a manual transmission
      2.14.5. Liquid level in automatic transmission
      2.14.6. Liquid replacement in automatic transmission
      2.14.7. Oil replacement in a transfer case
      2.14.8. Reducers of the forward and back bridge
      2.14.9. Oil replacement in reducers
   + 2.15. Cooling liquid
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






2.14.2. Replacement of oil and oil filter

GENERAL INFORMATION

Timely replacement of oil is the most effective measure applied by the owner to avoid premature wear of the engine owing to aging of oil, its razzhizheniye and pollution.

Before the beginning of works prepare the new filter which should correspond to the engine of your car (the filter it should be calculated on pressure about 17,6 atm (1764 kPas) and oil (the filled volume about 6 l). Oil should be changed on the heated-up engine.

PERFORMANCE ORDER
1. Warm up the engine.
2. Switch off ignition and unscrew a stopper of a jellied mouth.
3. Lift the car a jack.
4. Prop up the car a support.
5. Substitute the pallet under a drain stopper.
6. Unscrew a stopper.
7. Merge oil in the pallet. After running off of oil wipe a stopper pure rags and wrap a stopper. Densely tighten a stopper, watching to stripping a thread.
8. Substitute the pallet under the oil filter. By hand or a key unscrew the oil filter.
9. Wipe pure rags a place of a prileganiye of the filter on the block of cylinders.
10. Slightly oil for the engine rubber laying of the new filter and wrap the filter into place. Tighten the filter by hand while laying will not adjoin to a surface of the block of cylinders, then tighten on 3/4 turns.
11. Lower the car and fill in oil of the necessary brand, having finished level to the top mark.
12. Start the engine, in 10 seconds the lamp of pressure of oil should go out. If the lamp does not die away during 15–30 seconds, stop the engine, find and eliminate the reason.
13. On the working engine check tightness of a stopper of the pallet and the filter, having tracked these places within a minute.
14. Stop the engine and some minutes later again check oil level. If necessary add.