Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
- 1.1. Dashboard and control units
   1.2. Internal furnish
   + 1.3. Door locks
   1.4. Bulk mouth of a fuel tank
   1.5. Cowl
   + 1.6. Windows
   + 1.7. Hatch
   + 1.8. Seats and seat belts
   + 1.9. Safety airbag
   + 1.10. Devices and governing bodies
   + 1.11. Start of the engine and driving
   + 1.12. Ignition lock
   1.13. Anticreeping system
   1.14. Lock of a steering column
   1.15. Engine start in cold weather
   + 1.16. Automatic transmission
   + 1.17. Mechanical transmission
   1.18. Parking brake
   1.19. Brake pedal
   1.20. System of the hydraulic booster of brakes
   1.21. The sound signal warning about wear of brake shoes
   1.22. System of anti-blocking of brakes
   1.23. Lever of adjustment of height of a steering column
   1.24. Steering system with hydraulic strengthening
   1.25. Rear-view mirrors
   1.26. Heaters of rear-view mirrors
   1.27. System cruise control
   1.28. Adjustment of volume and air direction
   1.29. Heater / conditioner
   1.30. Conditioner switch
   1.31. Salon heating
   1.32. Heating of a windscreen and glasses of doors
   - 1.33. In case of an emergency
      1.33.1. An arrangement of a spare wheel, a jack and tools in the car
      1.33.2. Poddomkrachivaniye of the car
      1.33.3. Car lowering
      1.33.4. Wheel replacement
      1.33.5. Car towage
   1.34. Replacement of lamps
   1.35. Capacity of lamps
   + 1.36. Headlights of head light
   1.37. Lamps of illumination of back registration plate
   1.38. Lamp of illumination of a luggage carrier
   1.39. Lamps for reading cards
   1.40. Top plafond
   1.41. Top lamp of a stoplight
   1.42. Portable lamp
   1.43. Safety locks
   + 1.44. Identification numbers and information plates
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

1.33.4. Wheel replacement


In case at you will lower a wheel, stop the car in a safe place and muffle the engine.

1. Turn on the alarm system, expose a sign warning about malfunction, at sufficient distance from the car. Ask passengers to leave salon.
2. Establish the car on an equal, dense surface and put it on the parking brake. In order that the car did not sweep after its raising by means of a jack, block (1) lowered wheel, диагональио opposite to the lowered wheel (2).
3. Prepare a spare wheel, a jack, the handle of a jack and tools.
4. Put a spare wheel under a car body near a jack; it will reduce risk of receiving a trauma if the car comes off a jack.
5. Use specially provided key for removal of a cap from nuts of fastening of a wheel.
6. Turn off nuts of fastening of a wheel with the help гайковерта. Yet do not remove a nut (And – cars with steel disks, In – cars with cast aluminum disks)
7. Look subsection 1.33.2 for definition of a point of installation of a jack near the lowered wheel, then, establish a jack and lift the car so that the wheel ceased to concern the earth.
8. Remove nuts of fastening of a wheel, then remove a wheel.
9. Remove fastening of the cap (1) closing nuts of fastening, on the other side of a wheel.
10. Remove dirt from a surface of a nave of a wheel and from openings for fixing bolts on a wheel, then, establish a spare wheel.
11. Establish cap fastening on a spare wheel. Establish fastening so that his uvulas got to the corresponding cuts (1) on a wheel.


Cap fastening for a forward wheel has gold color, and fastening for a back wheel has rebryany color.

12. On cars with стальж disks of wheels establish nuts of fastening of a wheel (a conic form) the conic end inside, then, fix them fingers that the wheel did not dangle.
13. On cars with aluminum disks of wheels temporarily twirl raйки of fastening of a wheel (a nut with a flange) so that flanges concerned a wheel and it did not dangle.


If all four wheels were replaced with wheels with steel disks, use nuts of a conic form.

Never grease nuts or bolts of fastening of wheels, otherwise, they will reliably not keep.

14. Slowly lower the car then, gradually twirl all nuts of fastening of a wheel while they will not be tightened till the demanded moment of an inhaling.
The demanded moment of an inhaling is equal 100–120 N · to m.


At crackdown of fastening of a wheel, do not make too big effort. For example, do not press a foot on a wrench, and do not use very long ломик or a tube for increase in a shoulder when using гайковерта.

15. Lower a jack and get it from below the car. Put a jack back and establish the lowered wheel on an arm of a spare wheel. Repair the lowered tire as soon as possible.
16. Check pressure in the tire. The recommended pressure is specified on the plate established on inside of a door of the driver.


Еспи the steering wheel vibrates at car movement after wheel replacement, address to experts for check of balancing of this wheel.

For safety of driving try not to establish on the wheel car with tires of different type or to use wheels of the non-standard size.