Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
- 13. Electric equipment
13.1. Detection of malfunctions in electric equipment system
13.2. Tension check
13.3. Detection of short circuit
13.4. Check of reliability of grounding
13.5. Check of integrity of a chain
13.6. Finding of not closed chain
13.7. Safety locks
13.8. Burned-through crossing points
13.9. Automatic switches
13.10. System of safety of SRS (safety cushion)
+ 13.11. Heater
+ 13.12. Conditioner
+ 13.13. Cruise control
+ 13.14. Audiosystem
+ 13.15. Cleaners of glasses
+ 13.16. Devices and switches
- 13.17. Lighting devices
13.17.1. Headlights
13.17.2. Lamp replacement
13.17.3. Adjustment of a beam of light of headlights
13.17.4. Indexes and turn repeaters
13.17.5. Lamp of an additional signal of braking (1992-98)
13.17.6. Devices of internal lighting
13.17.7. Lamp of illumination of registration plate
+ 13.18. Protection devices of electric chains
+ 14. Electroschemes
|
Bunch adjustment down (1992-98)
|
|
1. Screw
2. Labels
3. Vial
4. Scale of the vertical indicator |
Bunch adjustment across (1992-98)
|
|
1, 4. Screw
2. Adjustment
3. Scale of the horizontal indicator
5. Scale
6. Black label
7. Red label |
The sizes for definition of the center of a headlight
The marked screen
Adjusting screws of a headlight
|
|
Shooters specified fastening screws. |
The provision of a light ellipse at the adjusted headlight
|
|
1. Horizontal of the center of a headlight
2. Vertical of the center of a headlight
3. Ellipse center
4. Zone of high illumination |
CARS OF 1992-98.
On these cars the bunch is necessary for adjusting only after headlight removal, this procedure does not belong to obligatory, carried out as the current maintenance.
| PERFORMANCE ORDER |
| 1. Establish the car on an equal platform, pump over a suspension bracket. |
| 2. Pressure in tires should correspond to norm, the tank should be completely filled (imitation by cargo at the rate of 0,8 kg/l of fuel) is allowed, and the seat of the driver is loaded with mass of 70 kg. |
| 3. Clear headlights. |
| 4. Adjust a vertical corner of a bunch for what rotating the adjusting screw, achieve that the vial of a vertical goniometer was established between two adjusting labels. The vertical corner at turn on 1 division changes on 12. |
| 5. Adjust a bunch across for what rotating the adjusting screw, achieve combination of red and black labels of the indicator. The corner across at turn on 1 division changes on 23'. |
| 6. If the bunch cannot be adjusted in such a way, address in car-care center. |
|
OTHER CARS
The bunch is regulated with use of the marked screen.
| PERFORMANCE ORDER |
| 1. Establish the car on an equal platform in 3 m from the screen, pump over a suspension bracket. |
| 2. Pressure in tires should correspond to norm, the tank should be completely filled (imitation by cargo at the rate of 0,8 kg/l of fuel) is allowed, and the seat of the driver is loaded with mass of 70 kg. |
| 3. Clear headlights. |
| 4. Define the center of a headlight for a marking and will draw (paste) a perekrestiya which centers settle down opposite to the centers of headlights. |
| 5. Rotating adjusting screws, establish a light ellipse of a passing beam of headlights as it is required. Adjustment of a driving beam thus is not required. |
|
|
|