Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
- 13. Electric equipment
   13.1. Detection of malfunctions in electric equipment system
   13.2. Tension check
   13.3. Detection of short circuit
   13.4. Check of reliability of grounding
   13.5. Check of integrity of a chain
   13.6. Finding of not closed chain
   13.7. Safety locks
   13.8. Burned-through crossing points
   13.9. Automatic switches
   13.10. System of safety of SRS (safety cushion)
   + 13.11. Heater
   + 13.12. Conditioner
   + 13.13. Cruise control
   + 13.14. Audiosystem
   + 13.15. Cleaners of glasses
   - 13.16. Devices and switches
      13.16.1. Guard devices / combination of devices
      13.16.2. Speedometer cable
      13.16.3. Indexes of pressure of oil, fuel and temperature level, voltmeter
      13.16.4. Printed-circuit board
      13.16.5. Multimeter
      13.16.6. Switches of screen wipers
      13.16.7. Block of switches (headlights, turn, glass cleaner)
   + 13.17. Lighting devices
   + 13.18. Protection devices of electric chains
+ 14. Electroschemes

13.16.7. Block of switches (headlights, turn, glass cleaner)

GENERAL INFORMATION

The block of switches on a steering column


1. Bottom cover 2. Overlay of the button of a sound signal 3. Wheel	4. Bottom casing of a column 5. Top casing 6. Switch

The block of switches is not folding and at refusal of any of switches changes entirely.

Removal and installation

PERFORMANCE ORDER

1. Take the measures excluding operation of a safety cushion.
	2. Remove a wheel.
3. On a part of cars of late release for access to the bottom casing of a column it is necessary to remove the bottom cover of the forward panel.
4. Remove the top and bottom casings of a column, disconnect the socket and get conducting from brackets.
5. Unscrew screws and remove the switch.
6. Establish the block of switches upside-down, center it on a column, otherwise after turn commission the switch of turns independently will not be disconnected.