Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
- 13. Electric equipment
13.1. Detection of malfunctions in electric equipment system
13.2. Tension check
13.3. Detection of short circuit
13.4. Check of reliability of grounding
13.5. Check of integrity of a chain
13.6. Finding of not closed chain
13.7. Safety locks
13.8. Burned-through crossing points
13.9. Automatic switches
13.10. System of safety of SRS (safety cushion)
+ 13.11. Heater
+ 13.12. Conditioner
+ 13.13. Cruise control
+ 13.14. Audiosystem
+ 13.15. Cleaners of glasses
- 13.16. Devices and switches
13.16.1. Guard devices / combination of devices
13.16.2. Speedometer cable
13.16.3. Indexes of pressure of oil, fuel and temperature level, voltmeter
13.16.4. Printed-circuit board
13.16.5. Multimeter
13.16.6. Switches of screen wipers
13.16.7. Block of switches (headlights, turn, glass cleaner)
+ 13.17. Lighting devices
+ 13.18. Protection devices of electric chains
+ 14. Electroschemes
|
The cable of a speedometer connects a reducer on transmission to the index of speed.
Replacement of a cable is necessary in case of its wear when characteristic noise published by a cable can be taken for malfunction of the engine. It is possible to determine malfunction of a cable by sharp jumps of an arrow of the index of speed.
On a part of cars the cable is connected to the generator of impulses, instead of with the index of speed. These impulses are used for management of a power supply system and ignition, and also will be transformed to indications of speed and the passable way. Replacement
| PERFORMANCE ORDER |
| 1. For replacement of a cable it is necessary to disconnect it from a check point. having unscrewed a cap nut, to remove a guard of devices and to disconnect from a guard a cover (see subsection 13.16). |
| 2. The cable gets from a cover. |
| 3. At cable replacement slightly grease its litoly (greasings 25 mm from the end should not be closer). |
|
|
|