Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
- 10. Suspension bracket and steering
   10.1. Wheels
   + 10.2. Forward suspension bracket
   - 10.3. Back suspension bracket
      10.3.1. Removal and installation of springs (1989-98)
      10.3.2. Removal and installation of springs (1983-89)
      10.3.3. Shock-absorbers of a back suspension bracket
      10.3.4. Back stabilizer of cross-section stability
   + 10.4. Steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

10.3.2. Removal and installation of springs (1983-89)

GENERAL INFORMATION

Correct installation of bolts of an earring of a spring

PERFORMANCE ORDER

1. Remove back wheels, disconnect a cable of the hand brake.

2. Substitute under the bridge 2 jacks, disconnect from the bridge shock-absorbers.

3. Unscrew nuts of step-ladders, turn on and get bolts of a back earring and a forward bolt of a spring, remove a spring.

4. Installation is carried out upside-down.

5. Bolts of fastening of a spring should be turned by heads outside.

6. Tighten nuts of step-ladders with the moment of 100-120 N of m, a shock-absorber bolt – with the moment of 18-25 N of m (after car lowering), a nut of a forward bolt of a spring – with the moment of 140 N of m, a nut of an earring of 45-60 N of m.