Mitsubishi Pajero

1982-1998 of release

Repair and car operation

Mitsubisi Padzhero
- 1.1. Dashboard and control units
   1.2. Internal furnish
   + 1.3. Door locks
   1.4. Bulk mouth of a fuel tank
   1.5. Cowl
   + 1.6. Windows
   + 1.7. Hatch
   - 1.8. Seats and seat belts
      + 1.8.1. Adjustment of a forward seat
      + 1.8.2. Back seat
      1.8.3. Folding of seats
      1.8.4. Raskladyvaniye of seats
      1.8.5. Head restraints
      + 1.8.6. Seat belts
   + 1.9. Safety airbag
   + 1.10. Devices and governing bodies
   + 1.11. Start of the engine and driving
   + 1.12. Ignition lock
   1.13. Anticreeping system
   1.14. Lock of a steering column
   1.15. Engine start in cold weather
   + 1.16. Automatic transmission
   + 1.17. Mechanical transmission
   1.18. Parking brake
   1.19. Brake pedal
   1.20. System of the hydraulic booster of brakes
   1.21. The sound signal warning about wear of brake shoes
   1.22. System of anti-blocking of brakes
   1.23. Lever of adjustment of height of a steering column
   1.24. Steering system with hydraulic strengthening
   1.25. Rear-view mirrors
   1.26. Heaters of rear-view mirrors
   1.27. System cruise control
   1.28. Adjustment of volume and air direction
   1.29. Heater / conditioner
   1.30. Conditioner switch
   1.31. Salon heating
   1.32. Heating of a windscreen and glasses of doors
   + 1.33. In case of an emergency
   1.34. Replacement of lamps
   1.35. Capacity of lamps
   + 1.36. Headlights of head light
   1.37. Lamps of illumination of back registration plate
   1.38. Lamp of illumination of a luggage carrier
   1.39. Lamps for reading cards
   1.40. Top plafond
   1.41. Top lamp of a stoplight
   1.42. Portable lamp
   1.43. Safety locks
   + 1.44. Identification numbers and information plates
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes

1.8.5. Head restraints


Adjustment of head restraints

Lever of adjustment of height of a head restraint:

At the left – type 1;

On the right – type 2

Soft head restraints from above backs of seats can reduce risk of injury of a neck in case of blow behind.


Head restraints can be rejected on two situation forward. If to try to incline them further, they will return to initial situation. Head restraints cannot be lifted or lowered.


For reduction of risk of receiving a trauma in case of collision adjust height of head restraints so that the center of a head restraint was up to standard of eyes.

To lift a head restraint, pull it up. To lower a head restraint, press on it, having taken away the handle of adjustment of provision of a head restraint in the direction specified by an arrow. After adjustment of height of a head restraint press on a head restraint to be convinced that it is reliably fixed.

Removal of head restraints

Adjustment handle:

At the left – type 1;

On the right – type 2

For removal of head restraints press on the handle in the direction specified by an arrow, and pull a head restraint up.

For installation of head restraints in the beginning check, that their forward party looked forward, then establish them on a seat back, having pressed on the adjustment handle, and lower them up to the end down that worked fixing latches. Check, that position of the adjusting handle was such, as is shown in drawing, and try to lift head restraints up to check, whether reliably they are fixed.

1. Forward seat

2. Back seat

3. Do not mix!


Driving without head restraints dangerously. Always operate the car with the established head restraints. If head restraints are not established, the probability of receiving a trauma in case of failure increases.

Head restraints for forward and back seats differ in a form. At installation of head restraints do not mix head restraints of lobbies and back seats. Head restraints of forward seats are higher and is thicker.