Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
- 4. Cooling system
4.1. Introduction
4.2. Electrofan
4.3. Replacement of cooling liquid
4.4. Water pump
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes
|
Plums of cooling liquid
| PERFORMANCE ORDER |
| 1. Establish the handle of adjustment of temperature of heating in extreme right situation, having opened thereby a heater tap.
|
| 2. Remove a stopper from a jellied mouth of a radiator. |
| 3. Turn out a drain stopper in the left lower part of a radiator and merge cooling liquid in the capacity substituted under a radiator. |
| 4. Merge cooling liquid from a broad tank. After cooling liquid will cease a leak from a radiator, wrap a drain stopper. |
|
Filling of system of cooling
| PERFORMANCE ORDER |
| 1. Fill in cooling liquid in a radiator to level of the top edge of a jellied mouth. |
| 2. Remove a stopper from a broad tank and fill in cooling liquid in a tank to level of a label of "Full". |
| 3. Start the engine and warm up it to working temperature (the thermostat should be open).
|
| 4. Finish level of cooling liquid in a radiator and a broad tank to norm and wrap radiator and tank jams. |
|
|
|