Mitsubishi Pajero

1982-1998 of release

GENERAL INFORMATION

Forward semi-axes

1. Guard
2, 3. Cap
4. Laying
5. Lock ring
6. Washer
7. Forward brake
8, 10, 12. Шплинт

9. Tip of steering draft
11, 13. Spherical support
14. Forward nave
15. Left semi-axis
16. Spring ring
17. Right semi-axis

Right semi-axes

1. Nave
2. External semi-axis
3. Internal semi-axis
4. Spring ring

5. Samopodzhimny nut
6. Arm
7. Case

Details of the right internal semi-axis

1. Semi-axis
2. Bearing
3. Cover

4. Case
5. Epiploon

Removal, installation and dismantling

PERFORMANCE ORDER

1. Before the beginning of works unblock naves of forward wheels.
2. Remove forward wheels, remove a forward brake, take aside and fix.
3. Remove the mechanism of blocking of a nave, get a lock ring of a semi-axis.
4. Vypressuyte a stripper a finger of steering draft, расшплинтовав and having unscrewed a nut.
5. Vypressuyte a stripper at first bottom, then the top spherical support, remove a nave assembled with a rotary fist and a pin.
6. Carefully get the left semi-axis.
7. Designate the provision of the right external semi-axis and remove it.
	8. Remove the right internal semi-axis (using MB990241-01 and MB990211-01 strippers).
9. Remove the case of the right semi-axis. For this purpose remove a spring ring of an internal semi-axis, unscrew a samopodzhimny nut of an arm of the case and remove an arm.
	10. At removal of the bearing unbend edges of a dustproof cover.
	11. Establish the adaptation for bearing fixing so that the facet And rested against a bearing holder.
	12. For a vypressovka of the bearing establish a semi-axis with the adaptation on whetstones and in blows of a hammer beat out a semi-axis.
13. Press from an internal semi-axis a cover, remove from the semi-axis case an epiploon.

Assembly

PERFORMANCE ORDER

	1. Press a new epiploon in the semi-axis case by means of the Mv990955-01 adaptation so that the surface of an epiploon was aflush with a case end face.
	2. Opravka of 75х4 mm press on an internal semi-axis a dustproof cover and fill a cover cavity with greasing.
3. Napressuyte on a semi-axis the bearing by means of a press and equipment (МD990560 and Mv998348-01).
4. Dress on a semi-axis new spring rings and insert into a reducer, пристукнув a rubber hammer, establish the case of the right semi-axis.
5. Attach the right semi-axis to internal, having tightened nuts with the moment of 54 N of m.
6. Establish the shock-absorber (if acted in film).
7. Establish a rotary fist with a nave (see fig. subsection 10.2.8).
8. Establish adjusting washers and a lock ring, check axial люфт which should be 0,2–0,5 mm. If necessary adjust люфт selection of washers.
9. Establish a nave cap, tighten bolts with the moment of 10-14 N of m.
10. Establish a forward brake and tighten bolts with the moment of 80-100 N of m.
11. Establish wheels and lower the car.