+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
- 8. Fuel system
+ 8.1. Carburetor engines
+ 8.2. Engines with fuel injection
- 8.3. Diesel engines
8.3.3. Fuel pump (TNVD)
8.3.4. Installation of the moment of injection of fuel
8.3.5. Adjustment of turns of idling
8.3.6. Adjustment of fast idling
8.3.7. Spark plugs
8.3.8. Fuel tank
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes
Tubes of system of injection and TNVD
For performance of procedure the indicator with the price of division of 0,001 mm with the special MD998384 extension piece is required.
| PERFORMANCE ORDER
| 1. Expose the piston of the 1st cylinder in VMT of a step of compression.
| 2. Release on the pump of the union of tubes of injection.
| 3. Release bolts and nuts of fastening of the pump to the engine.
|4. Check a vystupaniye of a rod of the extension piece of the indicator which 10 mm should be, if necessary adjust, rotating a nut.
|5. Turn out a cap from a head of the pump and screw the MD998384 adaptation.
|6. Carefully turn the crankshaft counter-clockwise, on 30 ° to VMT. The label (dredging) should be turned approximately at 11 o'clock.
|7. Establish an indicator scale on 0 and slightly turn the crankshaft in both directions, – thus the arrow of the indicator should be motionless. Otherwise repeat crankshaft installation on 30 ° to VMT, having achieved an arrow immovability.
|8. Turn the crankshaft clockwise, having combined a label with division 5 ° after VMT, – in this position of the crankshaft the indication of the indicator should be 0,997–1,003 mm.
|9. If the indication of the indicator differs from specified, moving the pump case, establish the necessary indications of the indicator then tighten nuts and bolts of fastening of the pump.
|10. Repeat procedure of installation and check the injection moment several times, - at each exposure of the crankshaft in 30 ° to VMT and 5 ° after VMT the indication of the indicator should be 0,997–1,003 mm.
|11. Replace copper laying and tighten a cap with the moment of 8 N of m.
|12. Tighten bolts and remove air.