Mitsubishi Pajero

1982-1998 of release

Repair and car operation


Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
- 6. Power supply system
   6.1. Introduction
   6.2. Air removal from a power supply system
   6.3. Water removal from the fuel filter
   6.4. Replacement of a filtering element of the fuel filter
   6.5. Removal and TNVD installation
   6.6. Idling adjustment
   6.7. Check of system of prestarting heating of the engine 4D56Т
   6.8. Control unit check by prestarting heating
   6.9. Check of the relay of inclusion of starting candles
   6.10. Removal and turbokompressor installation
   6.11. Check of pressure of pressurization
   6.12. Vozdukho-vozdushny cooler
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






6.6. Idling adjustment
PERFORMANCE ORDER
1. Adjustment of idling of the engine is necessary for carrying out on the heated-up engine, with the adjusted gaps in the gazoraspredeleniye mechanism, with correctly established initial corner of an advancing of injection, with a filtering element of the air filter pure and being on a place, at free moving of a cable of management by supply of fuel, the adjusting screw of idling on which tip should not press strongly on a control lever supply of TNVD fuel, at the switched-off consumers of a current.
2. Connect a tachometer according to the maintenance instruction and check frequency of rotation of a cranked shaft of the engine idling which should be within 700–800 rpm.
3. If necessary, rotating the adjusting screw (1) resting against a control lever supply of fuel (3), weaken a lock-nut (2) and establish demanded frequency of rotation of a cranked shaft.
4. After adjustment tighten a lock-nut of the adjusting screw and disconnect a tachometer.