Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
- 3. Engines
   3.1. Candles
   3.2. Check of wires
   + 3.3. Ignition system
   + 3.4. Major maintenance of the engine
   - 3.5. Diesel and turbodiesel engines 2,5 and 2,8 of l
      3.5.1. Removal and engine installation
      3.5.2. Engine dismantling
      3.5.3. Pistons and rods
      3.5.4. Valves and shaft of yokes
      3.5.5. Head of cylinders and valves, shaft of yokes and yoke
      3.5.6. Head of cylinders
      3.5.7. Compression check
      3.5.8. Camshaft and gas-distributing mechanism
      3.5.9. Drive of the mechanism of a gazoraspredeleniye
      3.5.10. Adjustment of gaps of valves
      3.5.11. Adjustment of a tension of a gear belt
      3.5.12. Removal of the bottom protective casing of a gear belt
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






3.5.10. Adjustment of gaps of valves

GENERAL INFORMATION

The provision of a label on a gear pulley of a camshaft

The label is specified by an arrow.

Adjustment of gaps of valves on the diesel engine


1. Cap key

2. Screw-driver

3. Shchup

For ensuring access to valves it is necessary to perform preliminary works. It belongs mainly to removal of the top protective casing of a gear belt and a cover of a head of cylinders. Exposed value of gaps of inlet and final valves makes 0,25 mm.
PERFORMANCE ORDER
1. Unscrew the top protective casing of a gear belt. The casing fastens four bolts on the forward party. Pull out a casing forward and drag under a water hose.
2. Disconnect from a cover of a head of cylinders a hose of ventilation of a case of the engine and a pressure head hose of a nadduvny obogatitel from the fuel pump of a high pressure.
3. Release a gas cable from a clip on a cover of a head of cylinders and put it aside, without bending.
4. Unscrew bolts of a cover of a head of cylinders and uncover. The semicircular sealing insert from the back party of a head of cylinders thus should not drop out.
5. Turn a cranked shaft before installation of the piston of the first cylinder in the provision of the top dead point. Thus should coincide a label on a gear pulley of a camshaft and a triangular label on the top part of the case of the gas-distributing mechanism, as is shown in fig. The provision of a label on a gear pulley of a camshaft.
6. At this position of the engine adjust gaps of the following valves: inlet and final valves of the first cylinder, inlet valve of the second cylinder, final valve of the third cylinder.
7. After that turn the engine on one turn and adjust gaps of the following valves: final valve of the second cylinder, inlet valve of the third cylinder, inlet and final valves of the fourth cylinder. At adjustment use a cap key, a screw-driver or shchupy the corresponding thickness. Put tools, as is shown in fig. Adjustment of gaps of valves on the diesel engine. Valves on the diesel engine are located, since the party with a water hose, in the following order: the final valve, the inlet valve and further in the same order to the fourth cylinder.